![]() When exiting the program an Error window pops up with C:/Program Digital Interface file not found error.Strange things are happening on my slow computer.The MMTTY RTTY Engine panel is always on top of the other windows.Why do I have a long delay going from Transmit to Receive?.A message lost sound briefly appears in the MMTTY waterfall.In Digital contests below the Multiplier List box no callsigns are shown. In Digital contests the Available Multipliers and QSOs Window does not show any multipliers or QSOs.The callsign to grab already scrolled off the screen (RX window) how do I grab it now?.What does it mean when a callsign is colored yellow in the Log window, or an exchange is green or red?.How do you delete a log or delete a database in N1MM?.How do you delete contests you don’t want any more, such as those used for testing purposes?.Sometimes it is correct for the contest, sometimes not. When I start the program it changes the mode on my transceiver.I’m sure the score shown by the program is not correct.Is my Sunrise and Sunset shown anywhere?.There is a missing section, county, oblast, etc.Is there a quick way of copying my buttons into his profile or do I need to re-type them in? My friend wishes to use the same digital/SSB/cw button legends and contents as me.I connect to packet, but no spots show up in the bandmaps.While sending CW my keying speed slowed but the display did not change.What will the program send when the exchange is a number? Sometimes, I don’t get what I’m expecting.When I change a callsign in mid-contact, the pre-filled exchange (if there is any) does not change.Now I’d like to re-start with my correct serial number and have it increment. A little later I discovered that I hadn’t entered 001 in the Sent Exchange. I started operating a serial number contest sending serial numbers by hand because the program wasn’t incrementing.The program just skipped a serial number (or sent a number out of order).Why doesn’t clicking on the band buttons in the Entry window change bands on the radio?.How can I modify the bands that are used for general logging? Normally I am QRV from 160m up to 3 cm (10 GHz).Can I customize the bands listed in the Available Mults and Qs window?.In ESM mode, the cursor jumps to the report field after the first time you press Enter, but what if the station doesn’t come back to you, and now the program is in the wrong state to call him again? How can I change this behavior?.Why Doesn’t CQ repeat work on VFO B? I already set it on VFO A.Is there any way I can avoid having the tab key jump to fields (like RST) that don’t normally need to be changed?.Do I have to retype the call to enter it? When I tune close to a station in the bandmap, the call appears in the frame above the callsign field.My security software detected a virus in an N1MM Logger download from the website.Where can I get the latest master.scp and country files? How do I get them into the program?.Can I install more than one copy of the program with different configurations?.Should I update every version, or is the latest update enough?.Would it be more prudent to lag by a few months, as I commonly do with other software?.Should I upgrade each time there is an update announcement?. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |